 |
 |
Vitek
Vitek Performance Ignition Wires |
Peak: 229.3 HP |
|
|
Manufacturer Pitch - Vitek Performance wires are manufactured with a unique stainless steel wire wound ("Mag Wire") conductor with a Dupont Kevlar core for superior pull strength. The conductor is insulated with an extrusion of pure gold silicone then braided with fiberglass to achieve ultimate mechanical strength of the finished product. The wire goes through extrusion of pure black silicone to finished diameter of 6mm, 8mm, or 9mm depending on the original equipment requirements. It should be noted that this construction offers superior dielectric properties and capacitance than larger diameter wires offered by some manufacturers as a marketing gimmick. Over size wires often won't fit for the boots and terminals. Bigger fatter wires offer virtually no dielectric advantage and many rigorously tested with high-energy systems on Street Racers, Nascar, and Drag racecars. Vitek street/race wire is rated at 850 Ohms per foot. Vitek also manufactures a 150 Ohm race wire available for certain selected applications. The race wire starts with a Kevlar center core and is coated with a layer of ferrite then spiral wound with nickel-copper alloy then recoated with ferrite. The wire then goes through 2 separate extrusions of a high temperature pure gold silicone to provide the maximum amount of dielectric properties and capacitance. The unique property of Vitek's reactive core plug wire is that the higher the heat and energy, the better the suppression capabilities become.
|
 |
|
Fit & Finish (Our Review) - The Vitek wires had an excellent fit at both the distributor and spark plug end. Lengths also made for a good fit.
|
|
| Cylinder #: |
1 |
2 |
3 |
4 |
| Length (cm): |
72cm |
56.5cm |
56.5cm |
41.5cm |
| Resistance (KOhms): |
5.46 |
4.05 |
2.50 |
2.77 |
|
Vitek Performance Products
531 South Main St. Dept. TPR
Alpharetta, GA 30004
Phone: (770) 663-7700 |
|
 |
|
© 2008 TPR / Tuner Performance Reports Magazine. |
|
|
|
|
